Farm Manuals Fast - Allis-Chalmers Manuals - Allis-Chalmers Tractor Manuals - Allis-Chalmers 160 and 6040 Tractors  - COMPLETE SERVICE MANUAL

Allis-Chalmers 160 and 6040 Tractors - COMPLETE SERVICE MANUAL


Allis-Chalmers 160 and 6040 Tractors  - COMPLETE SERVICE MANUAL This product is on sale

Product Description

This is the service manual for the Allis-Chalmers 160 and 6040 tractor.

This 150+ page technical manual is the exact one the repair shops use! It contains hundreds of pictures and diagrams containing all the information you need to repair and troubleshoot your AC tractor.



Original Price:
$49.99
Sale Price:
$24.99 (Save 50%)


Table of Contents

PART 1 - ENGINE

  • CLEARANCES AND TOLERANCES
  • CRANKSHAFT AND MAIN BEARINGS
    • Balance Weights
    • Crankshaft Data
    • Crankshaft A Rear End Oil Seal
    • Fitting New Main Beanngs and Thrust Washers
    • Regnnding the Crankshaft
    • Replacing Crankshaft
    • To Remove Crankshaft
  • CYLINDER HEAD
    • Adjusting Valve Gearance
    • General
    • Operation
    • Reassembly and Replacing
    • Rocker Levers and Bushings
    • Starting the Engine
    • Tappets
    • To Remove the Cylinder Head
    • To Remove the Valves
    • Valve Guides
    • Valve Seat Inserts
  • CYLINDER LINERS
    • Preparation for Fitting New Lines
    • To Fit New Liners
    • To Remove Linen
    • Unbored Cast Iron Liners
  • FAN AND DELCOTRON BELT ADJUSTMENT
  • FAULTFINDING
  • FLYWHEEL AND FLYWHEEL HOUSING
  • FUEL INJECTION SYSTEM
  • FUEL OIL FILTERS
  • LEFT SIDE VIEW OF ENGINE (160)
  • LEFT SIDE VIEW OF ENGINE (6040) 
  • LUBRICATING OIL FILTERS
  • LUBRICATING SYSTEM
    • Inspection 
    • Ofl Circulation
    • Oil Pressure
    • Oil Pressure Relief Valve
    • To Dismantle Oil Pump
    • To Reassemble the Oil Pump
    • To Re-fit Oil Pump
    • To RcmoveClean and Replace Sump Strainer
    • To Remove Oil Pump
    • To Remove Sump
    • To Replace Sump 
    • When to Remove The Oil
  • PISTONS AND CONNECTING RODS
    • Cast Iron Liners
    • Connecting Rod Weights
    • Fitting New Pistons
    • Fitting New Rings
    • Four Segment Type
    • Laminated Compression Rings
    • Three Segment Type
    • To Assemble Piston and Connecting Rod 
    • To Fit New Small End Bushings 
    • To Remove Pistons and Connecting Rods 
    • To Remove Piston Pins
    • To Replace Pistons and Connecting Rods 
  • PRIMING FUEL SYSTEM
  • RIGHT SIDE VIEW OF ENGINE
  • SPECIFICATIONS
  • TIMING
    • Fuel Pump Timing Marks
    • Tabic of Flywheel Degrees
    • Timing Marks
    • To Check Timing
    • To Reset Engine Timing
  • TIMING CASE AND DRIVE
    • Camshaft Thrust
    • Timing Gears
    • To Check Timing Gear Backlash
    • To Remove the Camshaft
    • To Remove the Camshaft Gear
    • To Remove the Fuel Injection Pump 
    • To Remove the Fuel Pump Gear
    • To Remove the Idler Gear and Hubs 
    • To Remove the Timing Case
    • To Remove the Timing Case Cover 
    • To Remove the Crankshaft Front Oil Seal 
    • To Replace the Camshaft
    • To Replace the Camshaft Gear
    • To Replace the Fuel Injection Pump
    • To Replace the Fuel Pump Gear
    • To Replace the Idler Gear and Hub
    • To Replace the Timing Case Cover 
  • WATER PUMP
    • To Dismantle Water Pump 
    • To Reassemoie Water Pump
    • To Refit Water Pump
    • To Remove Water Pump

 

PART 2 - Tractor

  • BRAKE ASSEMBLIES
    • Install
    • Remove
    • Separate Differential and Final Drive Housing from Transmission
  • CLUTCH HOUSING
    • Install
    • Remove
  • DRAFT CONTROL SHAFT
    • Install
    • Remove
  • FINAL DRIVE PINION & DIFFERENTIAL ASSEMBLY
    • Install
    • Remove
  • JUNCTION BOX
  • LIFT SHAFT
    • Hydraulic Lift Piston and Piston Seal
    • Install
    • Remove
  • POWER TAKE-OFF
    • Install
    • External PTO Shaft and Gear
    • Intermediate PTO Shaft and Gear
    • Upper Rear PTO Drive Shaft and Gear
    • Remove
    • External PTO Shaft and Gear
    • Intermediate PTO Shaft and Gear
    • Upper Rear PTO Drive Shaft and Gear
  • REAR AXLE
    • Install
    • Remove 
  • REAR AXLE (Differential) LOCK MECHANISM
    • Install 
    • Remove 
  • TRANSMISSION
    • Adjust Pinion Shaft Bearings
    • Assembly
    • Pinion Shaft in Housing
    • Synchromesh Unit
    • Disassembly
    • Main Transmission
    • Synchromesh Unit 
    • Transmission (Remove PTO Shaft)
    • Installation
    • Front PTO Shaft in Transmission
    • Gear Shift Lever to Transmission Cover
    • Pinion Shaft Sliding Gears, Synchromesh Assembly 
    • Range Transmission Countershaft
    • Range Transmission Shifter
    • Reverse Shaft and Gear Cluster 
    • Shift Lugs, Forks, Rods and Detent
    • Upper Main Shaft and Gears 
  • TRANSMISSION (Cont’d)
    • Removal
    • Gear Shift Lever from Transmission Cover
    • Pinion Shaft and Gears - - Synchromesh Assembly 
    • Range Transmission
    • Range Transmission Countershaft and Gears
    • Reverse Shaft and Gear Ouster
    • Shift Lugs Forks, Rods and Detent
    • Transmission Housing Assembly
    • Upper Mam Shaft and Gears
  • TRANSMISSION SHIFTING DIAGRAM
  • TWO STAGE ENGINE CLUTCH
    • Check and Inspect Clutch Parts
    • Outch Adjustment 
    • Clutch Pedal Adjustment
    • Disassemble Outch
    • Operation 
    • Optional Method of Assembling Outch
    • Reassemble Outch 
    • Remove Engine Outch from Tractor
  • WIRING DIAGRAM

 

Part 3 - Hydraulics

  • DRAFT SENSING SYSTEM
  • HIGH PRESSURE OIL FILTER
  • HYDRAULIC LINKAGE ADJUSTMENTS
    • Draft Control Lever
    • Sensing Spring
  • HYDRAULIC OIL FLOW CIRCUIT
  • HYDRAULIC PUMP
    • Assembly
    • Disassembly
    • Installation 
    • Removal
  • HYDRAULIC STRAINER AND LINES
  • LIFT ARM CONTROL VALVE
    • Lift Position
    • Lowering Position
  • LIFT ARM HEIGHT CONTROL
  • POSITION CONTROL AND LIFT - LOWER LINKAGE 
  • RELIEF VALVE BLOCK
    • Assembly
    • Disassembly
    • Installation
    • Removal
  • REMOTE RAM VALVE
    • Assembly
    • Disassembly
    • Installation
    • Lift Position
    • Lowering Position
    • Neutral Position
    • Removal 
  • SAFETY FEED BACK LINKAGE
  • SLOW LOWER AND POSITION CONTROL ADJUSTMENT 
  • POWER STEERING SYSTEM
  • POWER STEERING
    • Lines and Reservoir
    • Oil Row
    • Pump
    • Ram
    • Valve

Part 4 - Optional Equipment and Accessories

  • PROTECTIVE FRAME

 

Product Information

Pages:
164
Model:
160 and 6040
Make:
Allis Chalmers
Manual Type:
Service Manual